Kawai MP6 Manual de usuario descargar pdf (Pagina 33)

5. Control Knobs

The default parameters assigned for each knob are as follows.

A: #10 Panpot (PAN)

B: #70 Sustain Level (STN)

C: #76 Vibrato Rate (VbR)

D: #77 Vibrato Depth (VbD)

Note:

If the selected zone is set to BOTH, changing the MIDI CC# parameters aects both

internal and external sections. If you want dierent settings for internal and external

sections, enter the edit mode by pressing the MENU button and select internal or

external section with the ZONE SELECT button. (See page 35 for details.)

Changing MIDI CC parameter

Press and hold the ASSIGN button. ASSIGN button starts blinking and the cursor

in the display moves up to the parameter name.

1PA

N STN VbR VbD

0000

Use the CONTROL KNOBS to change the parameters.

After changing the parameter, press the ASSIGN button again. The ASSIGN

button stops blinking and the cursor in the display moves down to the value.

If “AFT” is selected, the modulation wheel is used to send After Touch

information.

Note:

When the selected zone is set to INT, only the following parameters can be

selected.

10 Panpot PAN

70 Sustain Level STN

71 Resonance RSN

72 Release RLS

73 Attack ATK

74 Cuto CUT

75 Decay DCY

76 Vibrato Rate VbR

77 Vibrato Depth VbD

78 Vibrato Delay VbY

93 Chorus Depth ChD

When the selected zone is set to BOTH and the internal section is selected in edit

mode, the parameters not available for INT section show as “ XXX”.

1015 STN VbR VbD

Ixx

x000

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 99 100

Sin comentarios

Kawai MP6 Manual de usuario Pagina 33